close
close

How To Light Pilot On Gas Fireplace With Remote

How To Light Pilot On Gas Fireplace With Remote. A standing pilot light is a small flame that burns even when using the fireplace in most gas fireplaces. When the fireplace or propane heater is turned on, the pilot light serves as an ignition source for the larger sweep of gas released from the burner.

Pilotlight switch for a gas fireplace? The Washington Post
Pilotlight switch for a gas fireplace? The Washington Post from www.washingtonpost.com

If you smell gas, don’t show the dare to light up the fireplace. When the fireplace or propane heater is turned on, the pilot light serves as an ignition source for the larger sweep of gas released from the burner. The function of a pilot light.

This Continuous Flame Is Necessary To Light Large Burners Such As Those Found In Gas Fireplaces.

This means that the pilot flame does not have to be kept on throughout the time when the gas fireplace is on. How to light your pilot. A pilot light is a small flame that is kept alight using a steady, small stream of gas.

From Off Position, Turn Gas Control Knob (Reads Off, On & Pilot) Counterclockwise To Pilot Position.

Wait at least 5 minutes to clear out any gas. Push in knob (this releases the gas to the pilot area only). Remember to shut the gas supply valve off (picture #1).

This Allows The Gas To Reach The Pilot Assembly.

Your valve may be located behind a ‘dashboard plate’ and that will not interfere with the lighting of your pilot light. Intermittent pilot ignition occurs when the ignition system has first to relight the pilot light before the valve systems open and allow the gas to pass and keep the ignition going. How to turn off your pilot light on a gas fireplace.

Get A Smart Thermostat Remote And Receiver.

If power is actively supplied to your fireplace, simply turn the on/off. How to light your pilot. If the log set has a switch on it, place it in the off position.

This Makes It Simple To Start The Fireplace When It’s Cold Outside, But Shutting Off The Pilot While It Warms Up Is A Good Idea.

Millivolts that close and open your gas valve. The thermocouple this is a small rod right beside your pilot light that takes in heat and sends the charge to the rest of the device, telling it to keep flowing gas. Locate the black knob on the left side (marked on/off/pilot).

Leave a Reply

Your email address will not be published.